Creating a Loop Surface

Used to create a surface from a selection of loops or surfaces. A tubular surface is produced. This is useful for modelling drives, voids and tunnels.

For this exercise we will use loop polygons.

1. Select the tunnel in the project explorer and choose to view it in a new view window.

2. Create polygon loops using Loop wrap if not already created

3. On the Create ribbon tab navigate to the Surface group and select Loop Surface.

   

Loop ordering

• Straight - Creates a single surface with the loops ordered along a straight line based on their orientation.
• Iterative - If there are two parts of a tunnel with a small gap between them it will automatically extract the boundary polygons of the surfaces and intelligently join the nearby loops of similar orientation. This can create multiple surfaces and wrap around corners if needed.

In the above example , there is data (points) with loops made using Loop wrap. By selecting the loop polygons and then Loop Surface, a single 'tubular' surface is produced.

The result of a single ‘tubular’ surface created.

 

In the above example, a Loop Surface was used on a selection of polygons and the process repeated three times.

 

These sections (above) can be hidden (using the Visibility Editor) from one another and each surface can be examined in a closer detail.

 

If there are only two loop surfaces, selecting both of them and applying a loop surface will create a new loop surface to fill the gap between the two loops.

 

Result of the new loop surface created between the original two surfaces.