View menu contents

Setup

Set the width of view when viewing Dragline sections using the View Current Section option.

View Current Section

Places the current section into a cross-sectional 3D view, as defined through the Setup option.

Change View

Step the view to another loaded section layer, by using a series of options.

Reverse View

Toggle the direction of view when looking in 3D cross-sectional view.

Coordinate

Display the 2D section coordinates (X, Y) and full 3D coordinates (X, Y, Z) of any point on the current section.

Distance

Measure the distance between nominated points on the current section.

Horizon Legend

Display a legend, showing the horizon numbers, colours, labels and surfaces of the horizon table.

Dragline Legend

Display a legend, showing the dragline information stored in the dragline database.

Reset Visibility

Restore the correct visibilities of the blocks and topographic strings.

Toggle Sections

Display or remove the dragline section arrows.

Toggle Surfaces

Display or remove the dragline surface strings.

Toggle Strips

Display or remove the strip objects created with the Create option.

Toggle Block Labels

Display or remove the block labels.

Toggle Templates

Toggle the visibility of templates.

Toggle Lines

Display or remove the vertical lines created using the Create option.

Toggle Points

Display or remove all named position point objects.

Toggle Other

Display or remove all Vulcan objects not created by the Dragline module that are stored in the dragline section layers.